Configure an LED Screen in COEX VMP

This tutorial describes how to setup NovaStar COEX processors that operate on the COEX VMP platform. This tutorial applies to NovaStar COEX processors under the models listed below: 

Applicable Processor Models:

• KU Series 
• MX Series
• CX Series

NOTE: LCT-based processors (VX Series, H-Series, MCTRL series) are not compatible with VMP. 

Before you get started

• Download and install the VMP software from the Downloads Page
• Ensure your LED screen is powered on and connected to the LED processor
• Ensure your processor is connected EtherNet LAN connection either directly to your computer or to a network switch.
• The processor and control computer must be in the same IP address range to be detected by the VMP software.

Still Need Help?

DVS offers complimentary first-time remote setup and training appointments with each system purchase. You can request a System Startup and Training Appointment here.